2” x 27’ 10K Ratchet Assembly w/flat hook

in

Click here to view larger image
Pic #3

Length: 27 feet

Width: 2 inches

Breaking strength: 10000 lbs

Safe working load: 3333 lbs

 

Caution: Check Safety Working Load limit as stated on this site as well as attached label to ensure the correct number of assembly is used for a given load. Each assembly is only strong as its weakest part so proper inspection prior to use is necessary as any damages may compromise the integrity of the unit. It is your responsibility to review the Federal D.O.T. regulations  regarding the handling and inspection of each component for safety. These units are not designed to or approved for overhead lifting. Never exceed Safety Working Load. Using corner protectors is recommended to protect webbing and cargo. Do not use any webbing or bungee products that show signs of excessive wear, nicks, cuts, abrasions, worn stitching, chemical burns, holes, or hardware is defective.

 

Safety Working Load: The maximum load a tie-down should be subject to during normal use. Safe working load should not exceed 1/3 of the rated capacity. Rated capacity: The minimum load a complete assembly will withstand before failure in a laboratory setting when the product is new.

Get A Quote Or Make An Order Now!

Previous post:

Next post: